Specify a tolerance factor that controls how closely zero-crossing events must occur to be considered consecutive.
Simulink® software defines zero crossings as consecutive if the time between events is less than a particular interval. The following figure depicts a simulation timeline during which Simulink software detects zero crossings ZC1 and ZC2, bracketed at successive time steps t1 and t2.
Simulink software determines that the zero crossings are consecutive if
dt < RelTolZC * t2
dtis the time between zero crossings and
RelTolZCis the Time tolerance.
Simulink software counts the number of consecutive zero crossings that it detects. If the count exceeds the value of Number of consecutive zero crossings allowed, Simulink software displays either a warning or error as specified by the Consecutive zero-crossings violation diagnostic (see Consecutive zero-crossings violation).
Simulink software resets the counter each time it detects nonconsecutive zero crossings (successive zero crossings that fail to meet the relative tolerance setting); therefore, decreasing the relative tolerance value may afford your model's behavior more time to recover.
If your model experiences excessive zero crossings, you can also increase the Number of consecutive zero crossings to increase the threshold at which Simulink software triggers the Consecutive zero-crossings violation diagnostic.
This parameter is enabled if Zero-crossing control is
set to either
Use local settings or
Enable all and Type is
|Type: character vector|
|Value: any valid value|
|Safety precaution||No impact|