Install support for Raspberry Pi™ hardware.
Connect Raspberry Pi Zero W to your computer using a USB cable.
Setup virtual CAN interface before configuring CAN Transmit and CAN Receive blocks.
Configure, connect to, and control Raspberry Pi hardware in Simulink® Online™.
Take steps to secure your Raspberry Pi in Simulink Online.
Troubleshoot issues in setting up and connecting to your Raspberry Pi in Simulink Online.
Configure the board to send you an email message whenever the IP address changes.
There are several ways to get the network settings of the Ethernet connector on your Raspberry Pi hardware.
Open a serial command-line session with Raspberry Pi hardware.
Get or set IP address of Raspberry Pi hardware.
Set up Raspberry Pi hardware as a Linux® desktop or terminal.
Extend Linux partition on the SD card for Raspbian Linux image.
Run Simulink models on Raspberry Pi without providing a password.
Shut down Raspberry Pi hardware.
Troubleshoot connecting to Raspberry Pi hardware.
Enable I2S drivers to output high-quality audio from Raspberry Pi using DAC.
When a Raspberry Pi hardware is directly connected to a computer using an Ethernet cable, perform these steps to access the Internet from the hardware.