MATLAB Answers

If i run PV model in matlab I have face this problem. Pls guide me how to solve this error. if I increase the time 1e-7 simulation is running but very slow.

11 views (last 30 days)
Dr. M. Venkateshkumar
Dr. M. Venkateshkumar on 31 Dec 2017
An error occurred while running the simulation and the simulation was terminated Caused by: Simulink cannot solve the algebraic loop containing 'pv970kw/PV Array 1/Diode Rsh/Product5' at time 5.0E-5 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues. To rule out solver convergence as the cause of this error, either a) switch to LineSearch-based algorithm using set_param('pv970kw','AlgebraicLoopSolver','LineSearch') b) reducing the VariableStepDiscrete solver RelTol parameter so that the solver takes smaller time steps. If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification.

  2 Comments

Shashank Kumar
Shashank Kumar on 1 Aug 2018
Place a unit delay block in Simulink model between the blocks where algebraic loop occurs. I hope this will help you.

Sign in to comment.

Sign in to answer this question.

Tags


Translated by