How to remove noise from a certain frequency using FFT
7 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I would like to know how to remove noises at a certain frequency using only the code below. Don't worry I have attached the sound file in the above so you use it. The problem I am facing is that I do not know how to do to find the index for this array to help cancel out all the noise greater than 3500 Hz or in this case the freq = 3500. I have the question of the code in here as well.
clear;
close all;
clc;
[y, Fs] = audioread('unfiltered_sound.wav');
dt = 1/Fs;
N = length(y(:,1));
nu_Ny = 1/(2*dt);
nu = linspace(0, 2*nu_Ny, N);
f = Fs*(0:(N/2))/N;
F = fft(y);
figure(1);
plot(nu, abs(F))
freq = 3500;
[~, ind] = min(abs(f-freq));
F_filtered = F;
F_filtered(ind:end-ind) = zeros(length([F_filtered(ind:end-ind)]),1);
%
figure(2)
plot(nu, abs(F_filtered))
%
y_filtered = ifft(F_filtered);
%
audiowrite('filtered_sound.wav', y_filtered, Fs)
6 comentarios
Sindar
el 21 de Sept. de 2020
what about compared to the original signal? Does it look like it is filtering the right area? If not, my first guess would be that 'f' and 'nu' are not consistent (or at least, not what you expect)
Respuestas (0)
Ver también
Categorías
Más información sobre Spectral Measurements en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!