Configure AUTOSAR Adaptive Data for Run-Time Calibration and Measurement
AUTOSAR Blockset enables you to configure run-time calibration of adaptive application data based on XCP server communication and ASAP2 (A2L) file generation. The XCP and ASAP2 capabilities are defined outside the Adaptive Platform (AP) specification, which as of Release 19-11 does not address data calibration.
As part of generating and deploying adaptive code, you can configure interfaces for XCP server communication in the generated C++ code and export A2L files containing model data for calibration and measurement.
Before deploying adaptive code:
In the Configuration Parameters dialog box, configure the model to generate XCP server function calls in adaptive C++ code and to generate an XCP section in an ASAP2 (A2L) file.
In the Share gallery under the AUTOSAR tab of the model, use Generate Calibration Files to generate ASAP2 (A2L) files that contain model data for calibration and measurement.
Configure XCP Communication Interface in Generated Code
To enable the communication capability, use the AUTOSAR adaptive model configuration
layer (Embedded Coder) to select an XCP transport layer. When Transport
layer is set to a value other than
Simulink® adds XCP server function calls to the generated C++ code. By default, the
tool uses the MathWorks® XCP server stack.
Selecting an XCP transport layer enables other XCP parameters. This image shows the XCP server model configuration parameters.
Using the model configuration parameters, you can:
Specify the transport layer that you want to use for communication.
Specify the target machine IP address and port number. You can use the port for only one application.
Optionally, enable verbose messages for XCP server.
Optionally, instead of the MathWorks XCP server, you can use a custom XCP server implementation based on the Ethernet transport layer. To use a custom XCP server, provide implementations for the functions declared in the XCP server header file by using the custom XCP server API commands. The XCP server header file is located in the MATLAB® installation folder
Add custom XCP server details in the configuration parameter Toolchain details or add the details manually to the
To generate ASAP2 (A2L) files, use Generate Calibration Files from the Share gallery under the AUTOSAR tab of the model. For more information, see Generate ASAP2 and CDF Calibration Files (Simulink Coder).