Modeling
Prepare Simulink® models for hardware connection, add blocks to support hardware protocols, reference examples featuring various applications.
Blocks
| Analog Input | Measure the voltage of analog input pin |
| Analog Output | Send analog output signal to DAC0_OUT pin |
| Digital Read | Read the logical value of digital input pin |
| Digital Write | Set the logical value of a digital output pin |
| FXOS8700 6-Axes Sensor | Get measurement of linear acceleration and magnetic field along the X, Y, and Z axes of the FXOS8700 6-Axes chip |
| I2C Controller Read | Read data from I2C peripheral device or I2C peripheral device register |
| I2C Controller Write | Write data to I2C peripheral device or I2C peripheral device register |
| Push Button | Read logical state of Push button |
| PWM Output | Generate pulse waveform on specified output pin |
| Quadrature Encoder | Measure rotation of encoder in ticks |
| Serial Receive | Read data from UART port |
| Serial Transmit | Send serial data to UART port |
| TCP Receive | Receive data over TCP/IP network from remote host |
| TCP Send | Send data over TCP/IP network to remote host |
| UDP Receive | Receive UDP message from UDP host |
| UDP Send | Send UDP message to UDP host |
Topics
- Tune Parameters and Monitor Data in Model Running on Target Hardware
Tune parameters and monitor a model running on your target hardware.
- Exchange Ethernet Data by Using UDP Blocks
The use of UDP blocks to exchange data between the development computer and the target hardware via Ethernet communication
- Model Configuration Parameters for NXP FRDM-K64F Board
Parameter and configuration options for creating and running applications on the target hardware.
- Log Signals on SD Card
Log signals from Simulink models on an SD card mounted on the target hardware.
- STEP 1: Prerequisites for Logging Signals
- STEP 2: Enable MAT-File Logging
- STEP 3: Configure Model to Log Signals on SD Card
- STEP 4: Run Model on Target Hardware
- STEP 5: Import MAT-Files into MATLAB
- Getting Started with Simulink Coder Support Package for NXP FRDM-K64F Board
This example shows you how to use Simulink® Coder™ Support Package for NXP FRDM-K64F Board to run Simulink model on a FRDM-K64F board.
- Code Verification and Validation with External Mode
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-K64F for code verification and validation using External mode.
- Read Temperature from an NXP FXOS8700CQ Sensor Available on NXP FRDM-K64F Hardware
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-K64F Board to configure and read temperature from an NXP FXOS8700CQ sensor which is a I2C based sensor.
- Exchanging Ethernet Data with the FRDM K64F Hardware
This example shows you how to use Simulink® Coder™ Support Package for NXP FRDM-K64F Board to send and receive UDP data.
- MAT-file Logging on an SD Card on NXP FRDM-K64F Board
This example shows you how to perform MAT-file logging from a Simulink® model on a Micro SD card mounted on NXP FRDM-K64F board.
