Histogram Y axis to Logarithmic Scale
262 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I trying to set the Y- axis of a histogram to Logarithimic Scale. I know I can use Y tick but I trying to figure out how I can get the best formulae for this I would be grateful for any help rendered.
hist(data(1:29196,3)) set(gca,'YTick',)
0 comentarios
Respuestas (2)
the cyclist
el 3 de Ag. de 2011
set(gca,'YScale','log')
3 comentarios
Tim Marks
el 3 de Abr. de 2017
I tried the cyclist's command
set(gca,'YScale','log')
on a histogram that I plotted in Matlab 2016b using the "histogram" command, and it worked like a charm. It kept the graph as a histogram, and just changed the y-axis to logarithmic scale, exactly as desired. Maybe it only works properly in recent versions of Matlab, but it did exactly what was needed.
Walter Roberson
el 3 de Ag. de 2011
The reason your histogram disappears is that the histogram draws each bar down to the value 0, and log(0) is -infinity, so the graphics engine chops off those lines.
Unfortunately changing this behavior is not easy if you require that hist() be used. When you use hist(), the drawn graphic is in the form of a patch. It is possible to set() new YData for the patch, but when you do so other internal aspects of the patch get changed and it ends up a mess.
What you are better off using is:
[n, xout] = hist(data(1:29196,3));
bar(xout, n, 'barwidth', 1, 'basevalue', 1);
set(gca,'YScale','log')
This will cause the bar graph to be drawn only from 1 upward instead of from 0 upward, and log(1) is not a problem to draw.
1 comentario
Jamie
el 22 de Jun. de 2018
This is great, thanks! I use basevalue of 0.1 so that single occurrences are visible.
Ver también
Categorías
Más información sobre Histograms en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!