How to change PWM Frequency of Arduino USING MATLAB SIMULINK Support package
34 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hello,
i have problem with my project. I use Arduino uno and Simulink. For the control i need a PWM signal with 3000 Hz - 5000 Hz but the Simulink support package (PWM) has only 490 Hz and i can change only the duty-cycle.
What can I do?
I would welcome your response
16 comentarios
Daniel Velazquez
el 9 de Jul. de 2021
You can change the frequency in Simulink just double click on the PWM block in the Frequency drop down menu select: Specify and write your desired frequency in Hz.
The problem is the higher the frequency (>100kHz) the lower the resolution of the PWM, but at 5kHz you should have no problem.
...as of July 8, 2021 with ATMEGA 2560.
Amin Gholizad
el 17 de Jun. de 2024
Is there any way to make the frequency variable for implementing a frequency modulation?
Respuestas (1)
Greg Wolff
el 15 de Ag. de 2019
You cannot change the PWM frequency of the PWM block found in the Arduino hardware support package.
You can however create custom device driver blocks. There is a good resource here:
that has various examples, all built around supporting Arduino boards.
0 comentarios
Comunidades de usuarios
Más respuestas en Power Electronics Control
Ver también
Categorías
Más información sobre Arduino Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!