Three-Phase PI Section Line Parameters
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
For the model that I am building I do not have access to zero-sequence impedance values for the conductors that I am using. Am I right in assuming that this will not affect my load flow and simulation results? Is there any way to calculate these values?
Thank you, Kyle
0 comentarios
Respuestas (1)
Joel Van Sickel
el 18 de Ag. de 2021
Hello,
as part of an effor to clean up matlab answers, this response is being made even though it is far too late to be of use to the asker:
You can ignore zero-sequence to get a basic idea of how your system will perform, especially if it is balanced, however, instead of leaving it at zero, you might consider making the same as your positive sequence (or a bit smaller) This is not ideal however. There are tools to help estimate these parameters if you know your conductor's geometry.
Regards,
Joel
0 comentarios
Ver también
Categorías
Más información sobre Simscape Electrical en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!