System Composer: how to create input/output port in system architecture model?
9 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi, I am new to system composer 2022a and trying to build system architecture using system composer. I have one input output physical interface(e.g CAN). How can i create input/output port for CAN? i tried creating two ports 1 input and 1 output using the same name but system composer doesn't accept same name for two ports. So is there a possibility to create one input/output port in system composer?
0 comentarios
Respuestas (1)
Josh Kahn
el 8 de Nov. de 2022
Hi Gadi,
The recommended method in System Composer would be to create in/out pairs of ports by name so you would have, for example: CAN_Ch1_In and CAN_Ch1_Out since bidirectional ports are not supported explicitely. You can then also apply the same interface to the ports for parity.
Josh
1 comentario
Josh Kahn
el 25 de Jun. de 2024
Note, if you are modeling message data across the bus, you should use the input/output pairs. If you are modeling the actual hardware behavior of the CAN bus, you can use physical ports instead, which are not directional.
Here is more information on physical ports:
Ver también
Categorías
Más información sobre System Composer en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!