TI Delfino 28379F and BOOSTXL-3PhGaNInv with sensorless BLDC Motor no motor signals
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Muhammed Zerey
el 5 de Ag. de 2023
Respondida: Ananth kumar
el 11 de Sept. de 2023
Hello everyone,
i am trying to run the above mentioned setup. When i build and deploy the software to the target hardware i dont get any errors. I also tried to run a simple programm with blinking LEDs to ensure that the Hardware is communicating with the board. I am using the official Matlab software to run a sensorless Motor (mcb_open_loop_control_f28379d). Also i am using a 14.8 Battery to supply the Boost XL Inverter. For the host serial setup, host serial receive and transmit i used the same com port of the TI Delfino.
Any help would be appreciated.
0 comentarios
Respuesta aceptada
Ananth kumar
el 11 de Sept. de 2023
This example should work out of the box. Please check your hardware individually, serial communication, ADC read, PWM. Or try the same with other set of hardware if you have.
But the shipping example is expected to spin the motor.
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Electromechanical en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!