how can I make the signalbuilder run
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
can I run the signalbuilder through Matlab script's ? if yes, so how ?
thank you
0 comentarios
Respuestas (3)
Abhiram Bhanuprakash
el 22 de Jun. de 2015
Hi Ahmed,
So, you can create a Simulink model with a signal builder block and then use sim to run it by command line.
You can also set block parameters of a Simulink block using set_param. You can query them using get_param. You can use these functions on the signal builder block to set or query block parameters.
Hope this helps,
Cheers!
Abhiram
Anthony Poulin
el 24 de Jun. de 2015
Editada: Anthony Poulin
el 24 de Jun. de 2015
Hello,
Do you want to select a specific group of your signal builder?
If YES, use the command: signalbuilder(block, 'activegroup', index) which sets the active group with the index that you specified. Then run your simulation, with the "sim" command (like Abhiram says).
Ver también
Categorías
Más información sobre Sources en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!