Please support me to solve this problem because the simulation stopped after 3.76 sec from starting by this error..?
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
An error occurred while running the simulation and the simulation was terminated
Simulink cannot solve the algebraic loop containing 'untitled/PV Array/Diode Rsh/Product5' at time 3.7605000000000004 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues. To rule out solver convergence as the cause of this error, either a) switch to LineSearch-based algorithm using set_param('untitled','AlgebraicLoopSolver','LineSearch') b) reducing the ode45 solver RelTol parameter so that the solver takes smaller time steps. If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification.
1 comentario
Walter Roberson
el 8 de Mayo de 2016
What happened when you used the command
set_param('untitled','AlgebraicLoopSolver','LineSearch')
and then re-ran?
Respuestas (1)
tret retret
el 17 de En. de 2020
I get the message :
what does it mean?
Warning: Changing property 'AlgebraicLoopSolver' is not allowed
2 comentarios
Ver también
Categorías
Más información sobre Linearization en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!