Cant get complete adc data using c2000 in external mode
6 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I am using c2000 ADC pins in external to monitor phase currents and voltages data using a hardware interrupt. The hardware interrupt uses ePWM for generating interrupt. I am trying to see the data on a scope, I am getting the data with a lot of missing points. I am running the model at a sampling time of 1ms. If I decrease the sampling time I get an error 'Failed to connect to target'.
Any ideas to solving this problem will be appreciated.
Thanks and regards, Akshay.
1 comentario
Respuestas (1)
Venkatesh Chilapur
el 16 de Feb. de 2018
Please run through TASK 3 from link below and see if it helps: https://www.mathworks.com/help/supportpkg/texasinstrumentsc2000/examples/parameter-tuning-and-signal-logging-with-serial-external-mode.html
0 comentarios
Ver también
Categorías
Más información sobre Motor Drives en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!