Updating the Active Power of a Three-Phase Parallel RLC Load during Simulation Run Time
5 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi all,
I have a simulink simulation that runs for 20s. At every 5s, it will perform a new set of calculations and update the variable 'R' in the workspace automatically via the 'assignin' command.
Now I would need to read in this updated variable into the Active Power (under block parameters) of the Three-Phase Parallel RLC Load in my simulink model. May I know if the set_param command is able to perform this function in this situation? Or is it impossible to write into the Active Power of the Three-Phase Parallel RLC Load?
Any help or advice would be greatly appreciated! Thank you!
Best Regards, Rachel
This
Best Regards, Rachel
0 comentarios
Respuestas (1)
Sabin
el 3 de Oct. de 2023
Probably best to use variable Resistor/inductor/capacitor in this situation. It is then possible to update the value during simulation.
Variable resistor in Simscape technology:
Variable resistor in Specialized Power Systems technology:
0 comentarios
Ver también
Categorías
Más información sobre Switches and Breakers en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!