MATLAB Answers

Initializing discrete states with Matlab functions

3 views (last 30 days)
retigi
retigi on 5 Jul 2018
Answered: Mark McBroom on 5 Jul 2018
I have the following hypothetical system:
The discrete delay element uses input port to initialize its state when enabled. When I check the system steps in debug mode I realized that simulink continue to execute/output "matlab function" even after the delay element is initialized properly. Therefore simulink simply wastes computational power for no reason during simulation phase.
Is there a way to disable the matlab function block after the discrete delay is initialized?

Accepted Answer

Mark McBroom
Mark McBroom on 5 Jul 2018
If you have a newer version of MATLAB, you can place your MATLAB Function block in a Simulink Initialize Function block as described here .
Alternately, you can use a pattern similar to the following to enable the MATLAB function for the first timestep only:
1. Put matlab fcn block into an enabled SS 2. Insert a constant block with value of zero, connect that to a unit delay block ( with initial value set to one) and then connect the unit delay block to the enabled SS. This should then only execute your matlab fcn block at init and t+1. It should be disabled for all subsequent time steps.

More Answers (0)

Products


Release

R2017b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by