GigE Camera Error: Unable to set PacketSize
14 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I'm trying to connect a GigE camera through a pleora PT1000 IP engine. I'm using Matlab 2012a. I'm getting an error of "gige: Unable to set PacketSize" when trying to preview or use getsnapshot. I've seen on a previous thread the same problem using 2010. The help there has not solved my problem. Any help would be greatly appreciated.
1 comentario
jonathan
el 25 de Jul. de 2013
I'm getting this same exact issue with the same pleora device. Have you found a solution to this yet?
Respuestas (1)
Evan
el 25 de Jul. de 2013
Editada: Evan
el 25 de Jul. de 2013
Have you tried setting the Packet Size property for your camera? Outside of matlab, you should make sure Jumbo Frames are enabled and set the value to the maximum allowed by your network card by going to:
Control Panel > Device Manager > Network Adaptors > Network Card Name > Advanced > Jumbo Frames
Then, in matlab, set 'PacketSize' to that value:
src.PacketDelay = value;
2 comentarios
jonathan
el 26 de Jul. de 2013
I did this, but forgot to set PacketSize in matlab as well. After imaqreset, it worked like a charm.
Ver también
Categorías
Más información sobre GigE Vision Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!