Why do i receive an error message when working on PIL simulation for F28388D?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
cagdas hisar
el 27 de Dic. de 2020
Respondida: cagdas hisar
el 23 de Feb. de 2021
Hi,
I am working on a Processor-in-the-loop simulation for F28388D. I configured all of the parameters as far as I know. But when the compiling is the end, I receive an error message about communication. I have shared all of the configuration steps below that I have captured. If you solve my problem, I will be happy about that.
Thank you.
Sincerely,
1) Hardware Board
2-a) Hardware Implementation Pane (Build Options)
2-b) Hardware Implementation Pane (SCI-A)
2-c) Hardware Implementation Pane (Extarnal Mode)
3) Serial Port on my PC
4) Controller block for PIL that I created using "rtwbuild".
5) I have changed the controller block with the controller1 PIL Block.
6) I couldn't set the Board Name.
7) Finally, I've tried to fix the problem. But I have received the same error message over and over.
8) Besides, here is my controlCARD's design and switch positions.
0 comentarios
Respuesta aceptada
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!