how can i bypass an input or output from a udf?
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
function[m2,P2P1,T2T1,Po2Po1]=oswbudf(m1,y,b1,cp,r)
in this udf sometimes i dont need the third and fourth output i just need the first two. so is there a way i can bypass these and just get the first two outputs?
also function[m2,P2P1,T2T1,Po2Po1]=oswbudf(m1,y,b1,t1,cp,r)
i need a way in which i give only one of the two inputs (from b1 or t1) and depending on the input that was given the udf executes different lines of code for each case. is this possible or should i write a separate udf file for that?
0 comentarios
Respuestas (0)
Ver también
Categorías
Más información sobre Fuzzy Logic Toolbox en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!