This example shows an audio plugin designed to enhance the perceived sound level in the lower part of the audible spectrum.
Small loudspeakers typically have a poor low frequency response, which can have a negative impact on overall sound quality. This example implements psychoacoustic bass enhancement to improve sound quality of audio played on small loudspeakers.
The example is based on the algorithm in . A non-linear device shifts the low-frequency range of the signal to a high-frequency range through the generation of harmonics. The pitch of the original signal is preserved due to the "virtual pitch" psychoacoustic phenomenon.
The algorithm is implemented using an audio plugin object.
The figure below illustrates the algorithm used in .
1. The input stereo signal is split into lowpass and highpass components using a crossover filter. The filter's crossover frequency is equal to the speaker's cutoff frequency (set to 60 Hz in this example).
2. The highpass component, , is split into left and right channels: and , respectively.
3. The lowpass component, , is converted to mono, , by adding the left and right channels element by element.
4. is passed through a full wave integrator. The full wave integrator shifts to higher harmonics.
is the input signal,
is the output signal
is the time index
5. is passed through a bandpass filter with lower cutoff frequency set to the speaker's cutoff frequency. The filter's upper cutoff frequency may be adjusted to fine-tune output sound quality.
6. , the bandpass filtered signal, passes through tunable gain, .
7. is added to the left and right highpass channels.
8. The left and right channels are concatenated into a single matrix and output.
Although the resulting output stereo signal does not contain low-frequency elements, the input's bass pitch is preserved thanks to the generated harmonics.
audiopluginexample.BassEnhancer is an audio plugin object that implements the psychoacoustic bass enhancement algorithm. The plugin parameters are the upper cutoff frequency of the bandpass filter, and the gain applied at the output of the bandpass filter (G in the diagram above). You can incorporate the object into a MATLAB simulation, or use it to generate an audio plugin using
You can open a test bench for
audiopluginexample.BassEnhancer using Audio Test Bench. The test bench provides a graphical user interface to help you test your audio plugin in MATLAB. You can tune the plugin parameters as the test bench is executing. You can also open a
timescope and a
dsp.SpectrumAnalyzer to view and compare the input and output signals in the time and frequency domains, respectively.
bassEnhancer = audiopluginexample.BassEnhancer; audioTestBench(bassEnhancer)
You can also use
audiopluginexample.BassEnhancer in MATLAB just as you would use any other MATLAB object. You can use
configureMIDI to enable tuning the object using a MIDI device. This is particularly useful if the object is part of a streaming MATLAB simulation where the command window is not free.
HelperBassEnhancerSim is a simple function that may be used to perform bass enhancement as part of a larger MATLAB simulation. The function instantiates an
audiopluginexample.BassEnhancer plugin, and uses the
setSampleRate method to set its sampling rate to the input argument
Fs. The plugin's parameters are tuned by setting their values to the input arguments
G, respectively. Note that it is also possible to generate a MEX-file from this function using the
codegen command. Performance is improved in this mode without compromising the ability to tune parameters.
 Aarts, Ronald M, Erik Larsen, and Daniel Schobben. “Improving Perceived Bass and Reconstruction of High Frequencies for Band Limited Signals.” Proceedings 1st IEEE Benelux Workshop on Model Based Coding of Audio (MPCA-2002) , November 15, 2002, 59–71.