Blocks for Embedded Targets
You can create models for embedded target applications by combining standard blocks and C-MEX S-functions.
You can use blocks from these sources:
Support packages that you install.
The Embedded Targets library (
Blocks from system toolboxes, such as the Instrument Control Toolbox™ and Vehicle Network Toolbox™, and support packages.
|Byte Pack||Convert input signals to |
|Byte Reversal||Reverse order of bytes in input word|
|Byte Unpack|| Convert |
|CAN Pack||Pack individual signals into CAN message|
|CAN Unpack||Unpack individual signals from CAN messages|
|SCI Receive||Configure host-side serial communications interface to receive data from serial port|
|SCI Setup||Configure host-side serial communications interface for host-side SCI Transmit and SCI Receive blocks|
|SCI Transmit||Configure host-side serial communications interface to transmit data to serial port|
|UDP Receive||Receive UDP packet|
|UDP Send||Send UDP packet|
- Model Setup
Configure model for code generation