With loop optimization, you can stream or unroll loops in generated code. Loop streaming is an
area optimization, and loop unrolling is a speed optimization. To optimize loops for
MATLAB® code that is inside a MATLAB Function block, use the
MATLAB Function architecture. When you use the
Datapath architecture, the code generator unrolls loops irrespective of
the loop optimization setting.
HDL Coder™ streams a loop by instantiating the loop body once and using that instance for each loop iteration. The code generator oversamples the loop body instance to keep the generated loop functionally equivalent to the original loop.
If you stream a loop, the advantage is decreased hardware resource usage because the loop body is instantiated fewer times. The disadvantage is the hardware implementation runs at a lower speed.
You can partially stream a loop. A partially streamed loop instantiates the loop body more than once, so it uses more area than a fully streamed loop. However, a partially streamed loop also uses less oversampling than a fully streamed loop.
HDL Coder unrolls a loop by instantiating multiple instances of the loop body in the generated code. You can also partially unroll a loop. The generated code uses a loop statement that contains multiple instances of the original loop body and fewer iterations than the original loop.
The distributed pipelining and resource sharing can optimize the unrolled code. Distributed pipelining can increase speed. Resource sharing can decrease area.
When loop unrolling creates multiple instances, these instances are likely to increase area. Loop unrolling also makes the code harder to read.
You can specify a global loop optimization by using the HDL Workflow Advisor, or at the command line.
You can also specify a local loop optimization for a specific
loop by using the
coder.hdl.loopspec pragma in
the MATLAB code. If you specify both a global and local loop
optimization, the local loop optimization overrides the global setting.
To specify a loop optimization in the Workflow Advisor:
In the HDL Workflow Advisor left pane, select HDL Workflow Advisor > HDL Code Generation.
In the Optimizations tab, for Loop Optimizations, select None, Unroll Loops, or Stream Loops.
To specify a loop optimization at the command line in the MATLAB to
HDL workflow, specify the
coder.HdlConfig object. For example, for a
enter one of the following commands:
hdlcfg.LoopOptimization = 'UnrollLoops'; % unroll loops
hdlcfg.LoopOptimization = 'StreamLoops'; % stream loops
hdlcfg.LoopOptimization = 'LoopNone'; % no loop optimization
To learn how to optimize a specific MATLAB loop, see
If you specify the
this pragma takes precedence over
HDL Coder cannot stream a loop if:
The loop index counts down. The loop index must increase by 1 on each iteration.
There are two or more nested loops at the same level of hierarchy within another loop.
Any particular persistent variable is updated both inside and outside a loop.
A persistent variable that is initialized to a nonzero value is updated inside the loop.
HDL Coder can stream a loop when the persistent variable is:
Updated inside the loop and read outside the loop.
Read within the loop and updated outside the loop.
You cannot use the
In a subfunction. You must specify it in the top-level MATLAB design function.
For a loop that is nested within another loop.
For a loop containing a nested loop, unless the streaming factor is equal to the number of iterations.