You can perform cross-network cosimulation when your setup comprises one machine running MATLAB® and Simulink® software and another machine running the HDL simulator. Typically, a Windows®-platform machine runs the MATLAB and Simulink software, while a Linux® machine runs the HDL simulator. However, these procedures apply to any combination of platforms that HDL Verifier™ and the HDL simulator support.
Before you cosimulate between the HDL simulator and MATLAB or Simulink across a network, perform the following steps:
Create your design and testing files.
Copy HDL Verifier libraries to the machine with the HDL simulator
Go to the system where you installed MATLAB. Then, find the folder in the MATLAB distribution where the HDL Verifier libraries reside.
You can usually find the libraries in the default installed folder:
where the variable shown in the following table have the values indicated.
|The location where you installed the MATLAB software; default value is
|The operating system of the machine with the HDL
simulator, for example, |
|The name of the library files for MATLAB and for Simulink (for example,
|The compiler used to create the library (for
For a list of all the HDL Verifier HDL shared libraries shipped, see Default Libraries.
From the MATLAB machine, copy the HDL Verifier libraries you plan to use (which you determined in
step 2) to the machine where you installed the HDL simulator. Make
note of the location to which you copied the libraries; you'll need
this information when you are actually establishing the connection
to the HDL simulator. For purposes of this example, the sample code
refers to the destination folder as
If you now want to cosimulate with MATLAB, see Performing Cross-Network Cosimulation Using MATLAB. If you want to cosimulate with Simulink, see Performing Cross-Network Cosimulation Using Simulink.
To perform an HDL-simulator-to-MATLAB cosimulation session across a network, follow these steps:
When you want to perform an HDL-simulator-to-Simulink cosimulation session across a network, follow these steps:
Next, run your simulation, add more blocks, or make other desired changes. For instructions on using Simulink and the HDL simulator for cosimulation, see Simulink as a Test Bench or Component Simulation with Simulink.