How can I overlay Simulink curves obtained when model parameters are changed?
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Michael
el 1 de Abr. de 2014
Editada: madhan ravi
el 5 de Dic. de 2023
Hello: I want to be able to overlay simulink scope plot curves obtained from different model parameter settings.
For example, I can generate a step transient curve for an open loop system and a step transient curve for a closed loop system, but how do I overlay the two plots on the same axis for comparison purposes.
Is there something in simulink similar to the "hold on" function in Matlab so that curves can be overlayed on the same axis?
Thanks
1 comentario
Stefanie Hiu
el 5 de Dic. de 2023
Hi did you ever find out how to do this? Because I am currently facing the same problem.
Respuesta aceptada
Fangjun Jiang
el 5 de Dic. de 2023
Not on the Scope block, but these days you can utilize the Simulink Data Inspector (SDI). Run simulation multiple times and then compare the same signal.
1 comentario
madhan ravi
el 5 de Dic. de 2023
Editada: madhan ravi
el 5 de Dic. de 2023
+1 and Answer Accepted Fangjun: yes, SDI makes life much easier and saves a lot of time to do MiL testing for example.
Más respuestas (0)
Ver también
Categorías
Más información sobre Sources en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!