Pause a process, using a NI USB6008

Hello, I have the following problem:

I have two sensors connected to a NI-USB6008 data acquisition device, and one analog output which turns on a flashlight.

The thing is that I need this flashlight to turn on a few seconds after the data is being received, and turn of a few seconds before the process ends.

I know that this device does not support clocked processes, because it has no timer inside, but is there a way that, by using pause or some similar command, I can control when the flashlight turns on and off?

Thanks in advance!

P.S.: I attached the script I'm using. Don't worry about the comments in spanish :)