Using only one USRP & PC to transmit and receive the data at the same time
10 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I am new to both Simulink and USRP hardware. Basically, what I am trying to do is just to send and receive the data using only one USRP n210. I have created a transmitter and receiver block separately. Transmitter could work fine and show the correct waveform when connecting to the oscilloscope. And receiver block could also will work if USRP is connected directly by a real signal generator. But when I tried to put transmitter and receiver block together, the oscilloscope showed nothing and the vector scope inside my model will only show some noise. There is not much examples about using Simulink to work with USRP hardware. Thanks for any help and answer.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/163100/image.png)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/163103/image.png)
0 comentarios
Respuestas (3)
Lin Khine
el 2 de Abr. de 2015
Can you please kindly tell me how did you enable overrun port in SDRu receiver?
0 comentarios
Lin Khine
el 2 de Abr. de 2015
Can I see the result of vector scopes for each transmitter and receiver?
0 comentarios
John Rodgers
el 27 de En. de 2016
Hi, Did you succeed to transmit and receive at the same time ? Regards, John
Ver también
Categorías
Más información sobre Communications Toolbox en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!