Step response error when using step
38 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
s=tf('s')
s=((-1.0024*(s+55.86)*(s+0.4987))/(s))
%pzmap(s)
zpk(s)
step(s)
I am recieving the error when trying to use the step function.
Error using DynamicSystem/step (line 95)
Cannot simulate the time response of improper (non-causal) models.
Error in test (line 12)
step(s)
0 comentarios
Respuestas (2)
Paul
el 6 de Sept. de 2021
An improper transfer function has a numerator with higher order than the denominator. In your case, the numerator is second order and the denominator is first order.
If you want to approximate the step response, you can augment the transfer function with an additional high frequency pole so that the numerator and denominator are both second order:
s = tf('s');
sys = ((-1.0024*(s+55.86)*(s+0.4987))/(s));
aporoximatesys = sys*tf(1,[.0001 1]);
Now you can plot the step response of approximatesys (make sure you pick a reasonably large final time), but it's only an approximation.
If you want the exact solution, you'll need to work it out by hand or use the Symbolic Math Toolbox. But the solution will be difficult to plot exactly.
0 comentarios
Chunru
el 6 de Sept. de 2021
Make the system casual (output does not depend on future input) before using step:
s=tf('s');
sys=((-1.0024*(s+55.86)*(s+0.4987))/(s^2)) % this is a casual system
%pzmap(s)
zpk(sys)
step(sys)
0 comentarios
Ver también
Categorías
Más información sobre Stability Analysis en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!