DC motor PI current control block not connecting
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi everyone,
I am trying to implement PI current control of a DC motor. I was using the controlled PWM voltage block and H-bridge for the same. I am unable to connect the output of the PI block to the input of the PWM block. I thought it may be because the output of the PI will have units of A and the PWM block was set of voltage. I tried connecting a resistor but again the wire was not connecting them. There is an option for 'unit expression' in the pwm block but I have no clue as to what should be written in there. Could anyone pl explain to me where I am going wrong?
0 comentarios
Respuestas (1)
Arkadiy Turevskiy
el 16 de Oct. de 2014
The output of PI Controller block is the Simulink signal, but the inputs of Controlled PWM Voltage block are Physical Signals- more on the difference here .
You need to convert Simulink signal to Physical Signals to connect two blocks. This example show exactly what you need to do - both in terms of connecting the blocks (look into Feedback Controller subsystem) and in terms of how to tune PID gains.
0 comentarios
Comunidades de usuarios
Más respuestas en Power Electronics Control
Ver también
Categorías
Más información sobre Specialized Power Systems en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!