Responce From Estimated SysID Modell in Simulink isn't the same as shown in matlab compare() function
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
I have recorded requested motor torque data and current position data.
Split them. From the first half of the data created iddata object EstimationData. From the second half ValidationData. Then run:
processModel=procest(EstimationData,'P3DZU');
then run:
compare(ValidationData,processModel);
shows following response with very good fit of 99,54 %.
Then following Sinulink structure is build:
Scope shows following picture:
So my question is, why doesn't the signals match ob Scope how they match in the figure after calling compare function()?
0 comentarios
Respuestas (1)
Nikhilesh
el 31 de Mzo. de 2023
Hi Iaroslav,
The possible reason might be the simulation parameters, also try adjusting initial conditions of simulink model to match that of validation data.
1 comentario
Ver también
Categorías
Más información sobre Linear Model Identification en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!