- Q leads D, rotor angle measured from A-phase to D-axis
- Q leads D, rotor angle measured from A-phase to Q-axis
- D leads Q, rotor angle measured from A-phase to D-axis
- D leads Q, rotor angle measured from A-phase to Q-axis
Flux weakening equation issue
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
i have modelled using subsystem block for flux weakening equation(IPMSM) which is available in mathworks website.but output of id,iq is not match with motor cad id iq.
Notes:8500 rpm 15 Nm
did i model properly?
0 comentarios
Respuestas (1)
Sabin
el 28 de Sept. de 2023
First, the equations are implemented based on constant parameters, basically ignoring some physical phenomena that motor cad may include. Second, I would check if the definition for axis transformation is the same in the equations you are implementing and in motor cad. It is not uncommon for FEM tools to use a different definition that what a control engineer would use. The are 4 possible definitions:
More about the axis definition you can find in the FEM-Parameterized PMSM doc page:
0 comentarios
Comunidades de usuarios
Más respuestas en Power Electronics Control
Ver también
Categorías
Más información sobre Electromechanical en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!