How to scope and print UART data from STM32F4 evaluation board?
6 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Jung Sunghun
el 6 de En. de 2024
Comentada: madhan ravi
el 7 de En. de 2024
Hello all,
I am currently struggling to find out how to scope and print out an array of hex data as shown below.
It currently shows all zeros although the oscilloscope shows some data going to and coming from the STM32F4 board.
All wiring setup is correct since I successfully tested some other tasks.
I appreciate your help in advance.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1583926/image.jpeg)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1583931/image.jpeg)
1 comentario
madhan ravi
el 6 de En. de 2024
Editada: madhan ravi
el 6 de En. de 2024
As the message says , the Stm32 board uses a local timer so simulation time is not based
Respuesta aceptada
Jung Sunghun
el 7 de En. de 2024
1 comentario
madhan ravi
el 7 de En. de 2024
Perfect, thanks for providing feedback. Will be always useful for others as well. I knew how to do it in STM32Cubeide but not in Simulink since I don’t have the license.
Más respuestas (0)
Ver también
Categorías
Más información sobre STMicroelectronics Discovery Boards en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!