Question regarding PX4 Flight controller

• Unable to find the location of PX4 Firmware in host computer. Perform Hardware setup screens and provide a location for the PX4 Firmware in the setup screens. how to solve it . I am unable to connect the PX4 Set up block with Mission Planner

Answer 1

[R]

Hi @ParulVivekSunder

To address your question about the PX4 flight controller and the firmware location issue, here are some steps and resources that should help you resolve the problem:

Ensure that your MATLAB release is compatible with the PX4 firmware. You can refer to the system requirements for the UAV Toolbox here.

Make sure that your hardware is one of the supported PX4 autopilots listed in the documentation: Supported PX4 Autopilots - MATLAB & Simulink

After installing the support package, it’s essential to complete the hardware setup step before using the support package with Simulink. As indicated in the error message, go through the hardware setup screens and provide the correct location of the PX4 firmware. Then ensure that you have followed all the setup and configuration steps for your particular system as listed in https://www.mathworks.com/help/uav/setup-and-configuration-px4.html

This should resolve the issue you’re experiencing.

If you continue to encounter problems, I recommend checking the following documentation for additional troubleshooting steps: https://www.mathworks.com/help/uav/px4/ug/troubleshooting-firmware-upload-px4.html

[ParulVivekSunder]

Thank you so much for helping me mate . I will follow the steps and furthur if I face any other issue I would like to seek help from you .

Thank you,

Regards