Mux to Bus error message
37 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Matthew
el 20 de Mayo de 2015
Comentada: Mujtaba Syed
el 13 de Oct. de 2021
I'm getting a strange error when trying to run one of our models in simulink: I'm being told 'The block diagram 'Filename' uses bus signals. However, the 'Mux blocks used to create bus signals' diagnostic is not configured to 'error'. To prevent modeling errors:'
Why am I getting an error message for something I've deliberately turned off? Due to the way the model interfaces with our software it has to have a mux creating a bus otherwise it won't work so I can't replace the muxes with buses.
1 comentario
Kevin Quigley
el 16 de Mayo de 2017
You accepted the answer, but it's unclear if using the suggested setting solved your problem or it prevented you from using your model as implied in your question.
What was the outcome of setting this to 'error'? Did you have to rework the model?
Respuesta aceptada
Vinod Sudheesh
el 27 de Mayo de 2015
Hi Matthew,
To avoid this error please navigate to
Model Configuration Parameters (Ctrl+E) >> Diagnostics >> Connectivity >> Mux blocks used to create bus signals:
and set the value to "error".
Please note that this diagnostic needs to be set to "error" whenever there is a bus signal in the Simulink model so as to ensure that there will not be any problems with block connections while compiling the model.
Hope this helps!
Vinod
9 comentarios
Más respuestas (1)
Ver también
Categorías
Más información sobre Data Types en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!