How to execute the Simulink model from Raspberry Pi?

1 visualización (últimos 30 días)
Ahmed Desoky
Ahmed Desoky el 8 de Mzo. de 2016
I have built a Simulink model consisting of three blocks (Pulse generator + Data Type Conversion + GPIO Write) to flash a LED.
I loaded it onto the board, and the model ran normally from the computer in both normal and external modes. The LED was flashing.
The Simulink model is converted into an executable that runs on the Raspberry Pi board. Typically, the executable is saved in the `/home/pi/LED_Test_rtt/MW/LED_Test` directory. The name of the executable is the same as the Simulink model name.
I made all steps which were mentioned in this link: Remote Execution of Linux® Commands
and the LED was not flashing.

Iniciar sesión para responder a esta pregunta.

Respuestas (0)

Categorías

Más información sobre Raspberry Pi Hardware en Help Center y File Exchange.

Etiquetas

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by