How to use more than 1 powergui in the same model?

Hello everyone, I am building a microgrid that I will be using for testing my multiagent system, which means that I know just a little in Matlab... In this microgrid, I need to have a PV, which works in discrete mode, and a wind turbine, which works in phasors mode, and an emergency DG, which works in continuous mode. Since they work in different powerguis, I cannot have them all in the same model. I thought at first to separate the models and use model reference (model block variant) to call them, but still this solution doesn't work. I am having really a hard time and I cannot figure out how to solve this issue. I need your assistance all please with a solution easy to understand and can get me off this problem. Thanks a lot all of you

[Mikaeil Eslami]

hi , could you find a solution? i have also the same problem with the same project.

[Taouba Jouini]

The same question has been asked on ResearchGate at two occasions: https://www.researchgate.net/post/How_to_have_two_powergui_in_the_same_model_in_Matlabhttps://www.researchgate.net/post/Is_there_a_way_to_use_both_a_phasor_and_a_discrete_powergui_in_one_matlab_simulink_model

Answer 1

[Sabin]

You can use multiple powergui blocks in a system that contains two or more independent electrical circuits that you want to simulate with different powergui solvers.

To do so, put each circuit in a different subsystem, and then add a powergui block inside each subsystem.

When you use more than one powergui block in a model:

• Do not place a powergui block in the top-level diagram.
• Place every independent model in a different subsystem.
• Place a single powergui block in the top level diagram of every subsystem.

https://www.mathworks.com/help/sps/powersys/ref/powergui.html