How can i change the output power of a wind turbine induction generator in simpowersystems, and how can I measure the output power?
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hello I've been trying to change the output power of a wind turbine induction generator from its menu window (shown below), but I can't figure out the change in power in the scopes I can't understand the resulting signals after I changed the nominal power.
Appreciate your help
0 comentarios
Respuestas (2)
Joel Van Sickel
el 17 de Sept. de 2020
Hello Qais,
you will also need to increase the power delivered to the motor. This will show up in the simulation as increase voltage and current.
Regards,
Joel
0 comentarios
Ibrahim Athamnah
el 3 de En. de 2022
Hello Qais,
I have almost the same problem.
If you solve it, please send to me the solution. My email is:
2019979009@ses.yu.edu.jo
0 comentarios
Ver también
Categorías
Más información sobre Wind Power en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!