??? In an assignment A(I) = B, the number of elements in B and I must be the same.
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
I have to write a program for school that can read the temperture in a rooftile dryingroom. A NTC will be connected to a data-acquiring card. but when I want to use formulas on the whole matrix this creates is gives the before stated error. Below is the relevant code (the last 2 lines produce the error):
...
s=daq.createSession('ni');
s.addAnalogInputChannel('dev1',0,'Voltage');
s.Rate=rate;
s.DurationInSeconds=tijdseenheid;
[data,time]=s.startForeground;
...
const_a=input('The value of consistant A: ');
const_b=input('The value of consistant B: ');
weerstand=input('The value of the resistor: ');
ubron=input('The value of the powersupply: ');
data(:)=((ubron-data)*weerstand)/data;
data(:)=const_b/log((data)/const_a);
...
1 comentario
Jan
el 12 de Mzo. de 2012
The error cannot be produced by two lines. Only one command can cause the error - afterwards Matlab stops.
Respuestas (1)
Tom
el 12 de Mzo. de 2012
I'm not entirely sure what the variables are, but you may be meaning to do an element-by-element divide, not a matrix divide: in this case use ./ not / to divide.
2 comentarios
Jan
el 12 de Mzo. de 2012
You definitely need the elementwise operators. If you've tried this already without success, post your trials here.
Ver también
Categorías
Más información sobre National Instruments Frame Grabbers en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!