How to Trigger based on a incoming data value?
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
hello, I am aquiring a serial data from a sensor via xpc target. The sensor sends data in a continuous mode. I want to seperate the data byte from the packet of data. For that I want to trigger the data on the basis of a header byte say(0xC2).So that i can know where the packet starts. Can you suggest a way to do this
1 comentario
Walter Roberson
el 16 de Mzo. de 2012
Is it certain that 0xC2 can never be part of the data stream, and can never occur as a checksum byte?
Respuesta aceptada
Rajiv Ghosh-Roy
el 20 de Mzo. de 2012
Please take a look at the white paper "xPC Target Serial Communication" available here http://www.mathworks.com/tagteam/68353_xPCTargetSerialCommunication.zip
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Target Computer Setup en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!