How can I add acceleration resistance to a driveline model?

I have built a model using Simscape Driveline/Simulink. I have added gradient, rolling and wind resistance to the model; however, I am not sure how to add acceleration resistance to the model. Any suggestions?

Answer 1

[Steve Miller]

There are many ways to limit the acceleration. The resistances you have already added do that already. I believe you wish to limit the input torque from your power source (engine, motor, or other). Depending on your power source, you could limit its maximum torque or you could limit the request from the driver using a Saturation block to modify the control signal.

--Steve