GUIDE openingFnc called more than once
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Yoni Sher
el 4 de Feb. de 2018
Comentada: Isaac Wolf
el 30 de Mzo. de 2018
Hi, Is there somewhere I can put GUIDE initialization code that is guarantied to be called exactly once? I've found that openingFnc is called every time the GUI gets focus, and I'm not happy with the "set a flag to indicate you've done this before" hack.
2 comentarios
Respuesta aceptada
Jan
el 5 de Feb. de 2018
Using a flag is perfect, but if ~(exist('flag') == 1) would be a very poor implementation. Remember that this would search in the complete Matlab path for the files 'flag.m', 'flag.mexw64', variables, Java classes, folders etc. also. This is slow and might not reflect what you need.
But adding a flag to the figure's ApplicationData is fine and secure:
flagIsSet = isappdata(FigureHandle, 'MyFlag');
setappdata(FigureHandle, 'MyFlag', true);
if flagIsSet
% run your code, which should run once only
end
Más respuestas (2)
Image Analyst
el 4 de Feb. de 2018
The OpeningFcn is not called more than once for me. I've never noticed that and I've written hundreds of GUIs. I have a line at the end of my OpeningFcn that does:
% Print informational message so you can look in the command window and see the order of program flow.
fprintf('Now leaving myGuiName_OpeningFcn.\n');
I ran it. Cleared the command window, then went back to the GUI to put it in focus, and the line did not show up in the command window. So I can't reproduced. I could debug it if you attached the .m file and .fig file.
4 comentarios
Isaac Wolf
el 30 de Mzo. de 2018
I had been having the same issue, and I found out it was due to an "ishandle()" call I had in one of my other functions to make sure the GUI was still open.
Walter Roberson
el 5 de Feb. de 2018
The CreateFcn callback for the GUI will only be called once when the figure is loaded from the .fig file. Be warned that this will occur before the handles structure is created. The order of CreateFcn for the various components is not explicitly defined in the documentation.
0 comentarios
Ver también
Categorías
Más información sobre Startup and Shutdown en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!