How to interpret negative D term from PID tuner?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Chamira
el 5 de Jun. de 2012
Editada: Arkadiy Turevskiy
el 3 de Mzo. de 2015
Hello:
I have been using the Simulink PID tuner to tune a controller (both continuous time and discrete time) and I noticed that the D term ends up being negative. The plant that is being controlled is a linear system and it is 3rd order (servo motor for a hard disk read/write head).
From my understanding the purpose of the derivative action in PID is to predict the error of the control system ahead by time Td (Td should be proportional to the D term in the PID tuner), which improves the stability of the control system. Therefore I was wondering how would you go about and interpret how a negative Td predicts the error? Any help is always much appreciated.
Thanks!
0 comentarios
Respuesta aceptada
Arkadiy Turevskiy
el 5 de Jun. de 2012
Editada: Arkadiy Turevskiy
el 3 de Mzo. de 2015
This section of the doc answers your question (please scroll down to the bottom of the page).
HTH.
Arkadiy
Más respuestas (0)
Ver también
Categorías
Más información sobre PID Controller Tuning en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!