Plotting in a for loop

115 views (last 30 days)
Janna Hinchliff
Janna Hinchliff on 23 Jan 2019
Edited: Adam Danz on 23 Jan 2019
I have a code that reads data in a set of files and does some plots and fits on the data. The code I have at the moment is:
D = uigetdir
S = dir(fullfile(D,'LIV Data T= *.mat')); % Makes a structure with all files
N = numel(S); % Counts number of files
CM = cool(N); % set colormap
fig1 = figure;
for ii = 1:N
T = load(fullfile(D,S(ii).name)); % Load each file as a structure
I = T.num(3:end,1); % Extract each parameter from full file and ignore first two data points - they're often dodgy
V = T.num(3:end,2);
P = T.num(3:end,3);
DataPoints = length(I);
thresh = find(P>LasingThreshold,1); % checks for when power is above threshold for fitting
fit = polyfit(I(thresh:round(DataPoints/3)),P(thresh:round(DataPoints/3)),1); %Need value of P to be greater than the laser threshold - this should be done better eventually
fitplot = polyval(fit, I); % evaluates fit as line
xlabel('Current (mA)')
ylabel('Power (mW)')
hold on
xlabel('Current (mA)')
ylabel('Voltage (V)')
hold on
This mostly works, however, the data points from the current power plot in the first loop are missing. The fit is still shown and in all of the following loops both the fit and the data points are on the graph. What is the problem with plotting the data points in the first loop?

Accepted Answer

Adam Danz
Adam Danz on 23 Jan 2019
Edited: Adam Danz on 23 Jan 2019
On the first iteration of the loop, the "hold on" command isn't called until after the first plot() object is overwritten. To fix that, move the "hold on" command to the line shown below.
%your code....
hold on %<---- move here
xlabel('Current (mA)')
ylabel('Power (mW)')
%hold on % remove this

More Answers (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by