Error using table (line 253) All variables must have the same number of rows.
120 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Ali Mulhi
el 15 de Mzo. de 2019
Comentada: Peter Perkins
el 18 de Mzo. de 2019
i don't know why there's an error with my table. all varibales have 25 values.
here's my code
step= (0.0:0.2:5)';
Psi0= psiO(:,1)';
Psi1= psiO(:,6)';
Psi2= psiO(:,11)';
Psi3= psiO(:,16)';
Psi4= psiO(:,21)';
Psi5= psiO(:,26)';
table(step,Psi0,Psi1,Psi2,Psi3,Psi4,Psi5)
3 comentarios
per isakson
el 17 de Mzo. de 2019
Editada: per isakson
el 17 de Mzo. de 2019
step= (0.0:0.2:5)';
>> length( step )
ans =
26
Respuesta aceptada
KSSV
el 15 de Mzo. de 2019
Editada: KSSV
el 15 de Mzo. de 2019
The first input is a column and rest are rows..so the error. Try:
table(step,Psi0',Psi1',Psi2',Psi3',Psi4',Psi5')
You need to rethink on your code. The initilaization and calling th eindices is not good.
3 comentarios
KSSV
el 15 de Mzo. de 2019
It is not strange.......either you should input all rows or columns.....in my case I used all columns.
YOu have transposed the first input to a row from columna nd rest all are rows....
Más respuestas (1)
Peter Perkins
el 15 de Mzo. de 2019
Psi0 = array2table(psi0(:,[1 6 11 16 21 16])
would have been helpful for this. And then addvars to add step at the beginning.
2 comentarios
Peter Perkins
el 18 de Mzo. de 2019
addvars lets you add new variables in the middle. It's really the only reason why it even exists.
Ver también
Categorías
Más información sobre Signal Generation and Preprocessing en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!