problems connecting a Voltage Measurement Block to parallel RLC branch circuit.

5 visualizaciones (últimos 30 días)
RE: SimPowerSystems. When I try to connect a Voltage Measurement block to a "terminal" on the Parallel RLC branch block all I get is a dashed red line indicating no connection.
When I instead try to connect to the branch in the middle of the existing connection line, a "tie point" is created and the connection turns black. It appears to connect properly. Alas when I attempt to run the simulation it indicates that the voltage measurement block input is not connected.

Respuestas (1)

Joel Van Sickel
Joel Van Sickel el 11 de Dic. de 2020
I'm sorry this answer comes too late to be useful:
It sounds like the first issue is a UI bug preventing connection of lines that should work. As I can no longer check the images, I must assume that in the 2nd case, the voltage measurement was not connected correctly such as to give the correct output. That issue has certainly been fixed at this point.

Categorías

Más información sobre Variable Initialization en Help Center y File Exchange.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by