- The correct board is not selected in the Hardware Implementation section of Model Parameters.
- The functions/blocks being used do not support codeGen.
- The required support packages are not installed.
error conected arduino mega 2560 with simulink r2019B
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
julian ferreira
el 28 de Sept. de 2019
Editada: Shashwat Bajpai
el 1 de Oct. de 2019
Hello everyone I am working with arduino mega 2560 and linking it with simulink by external mode, I have the r2019b version but every time I am going to run my program with the external mode this error appears
the model that you are trying to run in external mode does not match the application running on your target. checksum test (target_data_map) failed. the host model's structural checksum is [1380959609, 1364613779, 4133718802, 3635779683] and the target application's structural checksum is [3140615652, 2212887576, 351826669, 3173125374]. rebuild the model, run it on your target, and start external mode simulation again
I've been finding out but there's still no solution to this problem, I appreciate the collaboration Thank you
0 comentarios
Respuesta aceptada
Shashwat Bajpai
el 1 de Oct. de 2019
Editada: Shashwat Bajpai
el 1 de Oct. de 2019
According to my understanding the “mismatch” error is possible because of three reasons:
I would be in a better state to help, if I could look at the model you are trying to implement.
Please refer the following documentation for further information:
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Modeling en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!