Ramp up/down function based on the variable input in Simulink/Matlab

Hi,

I am kind of new to Simulink and I am having trouble trying to generate an output signal (as attached) which will be ramped up and down to a certain setpoint depending on the input signal. I have tried using the ramp up function with min block but so far this combination could not generate the desired output. The output stops ramping up after it reaches to the first setpoint.

Any suggestions? Your help is really appreciated.

[Raj]

I am not quite sure what you are looking for. Do you want to create this custom signal in simulink? Maybe you can use the Signal builder/Signal Editor block.

[Aung Myat]

Hi, I am not simply trying to build the signal. I am trying to create a function which can generate such output. For example, if I want my output to be 850 (initially zero), the function should yield the output in a ramping up manner, not changing the output instantly. The same goes when I need the output to be lower than the current value, the function should yield the output in a ramping down manner. So, the signal of this function block should look like the graph which I attached.

[Raj]

In that case you should use the 'Rate Limiter' block. See this simple example:

This will give you output like this:

Where blue is your input and yellow is output. So instead you get "output in a ramping up manner, not changing the output instantly". This holds good for ramp down also. You can change the settings of the rate limiter block to get the desired output slope. Hope this helps!

[Aung Myat]

Hi Raj,

This helps. Btw, is there anyway to set the upperlimit and the lowelimit of the output?

Thank you!

[Raj]

Well you can set the final value in your 'Step' block or you can use a saturation block to limit the output within predefined boundaries.

[Aung Myat]

Hi Raj,

Thank you very much for your suggestion.

[José Carlos Ortiz Hernández]

Hi Aung Myat,

I am developing the same program and I have many problems. How could you solve it?