Simulation of PMSM Current Control using FCS-MPC
6 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi everyone
I'm trying to control a pmsm current using finite control set MPC, when I'm using PMSM model in simscape everything is fine and currents can track id and iq (currents in dq reference frame) but the problem is PMSM model is based on modified park transform (90 degree behind phase a) and our calculations are based on the original park.
when I change the PMSM model park transform to original park, the results change and FCS-MPC does not work properly.
does anybody have this problem?
Thank you in advance
2 comentarios
Harish Kumar Coimbatore Rajaram
el 16 de Abr. de 2020
Can you Share you Simulation file(Both Matlab script parameters used and the Simulink file) ??
Mouad Alioua
el 7 de Jun. de 2022
good morning sir
can you send the model for me please
mouad1521998@gmail.com
Respuestas (1)
Shang-Chuan Lee
el 10 de Jun. de 2022
Hi Hossein,
It sounds to me the rotor angle definition of PMSM isn't aligned with your control algortihm where the Park/Clarke Transform on the dq-axis. I would suggest first check the current signals to the "Park Transform" block as well as the "Clarke Transform" block from the current measurement signals.
Best,
Shang-Chuan
0 comentarios
Ver también
Categorías
Más información sobre Permanent Magnet en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!