How to reset diagnostics for particular block?
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hi, In my simulink simulation I am using a "transport delay" and I think I have disabled some diagnostics regarding this block. But I can not find them. I am trying to find out the buffer size I need to set for one of my simulations but I never get the warning that is mentioned in the help files when the initial buffer size is set to low (even when setting the initial buffer extremely low):
Initial buffer size
Define the initial memory allocation for the number of input points to store
Settings
Default: 1024
- If the number of input points exceeds the initial buffer size, the block allocates additional memory.
- After simulation ends, a message shows the total buffer size needed.
Does anyone know how I can rectify this?
1 comentario
Kaustubha Govind
el 1 de Nov. de 2012
What is the Maximum Delay setting and what do you provide for the second (transportation delay) input? Perhaps even the extremely low buffer size that you specify is sufficient for your signal if the delay is small enough?
Respuestas (0)
Ver también
Categorías
Más información sobre Configure and View Diagnostics en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!