Cannot boot RTTarget-32 from Virtual 8086 mode
5 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi, when took an example about xPC Target Stand Alone in matlab help 2012b, i took the steps in the help, and the only different was tha i had not edit the autoexec.bat located in the C:\ with dos commands, i edit it in xp with txt in xp syttem insteard, and when i finished transfering file from the host computer to the target computer and editing the autoexec.bat. i reboot my target computer in dos system, but the system returned some information as below: "RTTarget-32 DOS Boot Utility 5.23(c) 1996,2011 On Time Informatik GmbH Cannot boot RTTarget-32 from Virtual 8086 mode"
and the target computer had not run the model i transfered to it, could anybody give me some favour about these prombles, or is there anybody who met the same problems.
3 comentarios
Respuestas (0)
Ver también
Categorías
Más información sobre Multicore Processor Targets en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!