How to enable the signal visualization blocks in the "QPSK Receiver with ADALM-PLUTO Radio" example?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
MathWorks Support Team
el 15 de Dic. de 2020
Editada: MathWorks Support Team
el 18 de Abr. de 2024
I am trying to use the signal visualization blocks found in the following example (QPSK Receiver with ADALM-PLUTO Radio):
However, I can not find a way to activate these signal visualization blocks as the process to do so is not mentioned in the example documentation.
I had noticed that one sentence in the doc says, "To ensure real-time processing, the model is by default set to run in Accelerator mode, and to remove all signal visualization", but when I tried running the model in Normal mode there was no change. How do I activate these blocks?
Respuesta aceptada
MathWorks Support Team
el 18 de Abr. de 2024
Editada: MathWorks Support Team
el 22 de Dic. de 2021
In the example model, if you double click on the QPSK receiver block, you will see the spectrum analyzer and constellation diagram blocks (4 blocks in total) as shown below.
Please right-click on each of these blocks and select 'Uncomment'. Uncommenting all these four blocks should show you the visualizations.
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre RF Component Modeling en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!